Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Stick a mirror tile on the floor, run a battery LED strip round the walls below the ledge, and lay a one-way-mirror acrylic sheet on the ledge. Prints as shown on its floor, no supports.
Print in gold or rose; engrave initials with a marker or a rotary tool on the body. Prints as shown on its outline, no supports.
Push stud posts through the pod holes; the backs sit safely in the chamber underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in a deep green; a 0.2 mm layer keeps the slit ends crisp. Prints as shown on its outline, no supports.
Print the cap in brown and the body in tan; the ring stands in the gap round the centre post. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in a pale gold; the tilted ring ends make tidy cradles for single rings. Prints as shown on its outline, no supports.
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print disc face down; two screws through the boss. Prints flat as a plate, no supports. Stacked parts are fused into one print.