Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Hair tie and clip carousel
MAIN PURPOSE: Spin hair ties, clips and slides
A low six-section carousel that spins on BBs for hair ties, clips and slides.
Printing notes
254.4 cm³
Volume
315.4 g
Est. weight
6,144
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Bobby pin tin
MAIN PURPOSE: Keep bobby pins together
A tiny round tin with a press-on lid and ring pull for bobby pins.
Printing notes
24.2 cm³
Volume
30.0 g
Est. weight
1,848
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Earring box with lid
MAIN PURPOSE: Store earring pairs in a lidded box
Sixteen small pockets for earring pairs, with a press-on lid.
Printing notes
122.3 cm³
Volume
151.6 g
Est. weight
1,784
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
