Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Two-tier vanity box
MAIN PURPOSE: Sort vanity items in two tiers
A six-cell vanity box with a second tier and a telescoping lid.
Printing notes
275.2 cm³
Volume
341.2 g
Est. weight
456
Triangles
Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Rotating two-tier vanity carousel
MAIN PURPOSE: Spin to reach makeup on two tiers
A spinning vanity carousel with a smaller tier stacked on top.
Printing notes
579.3 cm³
Volume
718.4 g
Est. weight
6,872
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs. Stacked parts are fused into one print.
Cotton round tower
MAIN PURPOSE: Store cotton rounds under a lid
A tall round tower for cotton rounds with a lid.
Printing notes
87.6 cm³
Volume
108.6 g
Est. weight
1,552
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Spinning cosmetics tower
MAIN PURPOSE: Spin cosmetics to reach them easily
A tall six-section cosmetics tower with a centre hub that spins on BBs.
Printing notes
635.4 cm³
Volume
788.0 g
Est. weight
6,144
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.