Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Punch sewing holes in book signatures
Fold a book signature into the V and poke the sewing holes straight through the slot along the bottom with an awl, so every page lines up for sewing.
Printing notes
439.1 cm³
Volume
544.5 g
Est. weight
592
Triangles
Print as it comes, V outline on the bed; lay it on its side to use it.
Mini display easel
MAIN PURPOSE: Display postcards, photos and small art
A small easel that shows off a postcard, a photo, a tile or a small canvas at a gentle lean; the front ledge stops it sliding off.
Printing notes
66.2 cm³
Volume
82.1 g
Est. weight
380
Triangles
Print as it comes, side outline on the bed; stand it on its base.
MAIN PURPOSE: Hang a bag or headset at a desk
Slides onto a desk or table top up to 25 mm thick and gives a hook at the edge for a handbag, a backpack or a headset, keeping them off the floor.
Printing notes
35.5 cm³
Volume
44.1 g
Est. weight
624
Triangles
Print lying flat so the layers run along the hook; PETG.
Drafting set square
MAIN PURPOSE: Draw right angles and 45-degree lines
A 45-degree set square for technical drawing, model making and marking out: slide it along a ruler or a T-square for parallel lines, verticals and 45-degree angles.
Printing notes
35.8 cm³
Volume
44.4 g
Est. weight
1,272
Triangles
Prints flat as a plate, no supports.
Fountain pen flushing cup
MAIN PURPOSE: Clean fountain pens
A two-chamber cup for cleaning fountain pens: flush the nib in the first chamber, rinse in the clean water of the second, and dry it on the rounded rim.
Printing notes
47.1 cm³
Volume
58.4 g
Est. weight
864
Triangles
Prints as shown on its floor, no supports.
Pencil grip trainer
MAIN PURPOSE: Teach children to hold a pencil
A triangular grip that slides onto a pencil and guides a child's fingers into the tripod grasp, making handwriting less tiring.
Printing notes
4.9 cm³
Volume
6.0 g
Est. weight
200
Triangles
Print in TPU for a soft grip. Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep drinks off a busy desk
Clamps to a desk top up to 25 mm thick and holds a mug, a can or a water bottle just off the edge, so drinks never end up over the keyboard.
Printing notes
53.5 cm³
Volume
66.3 g
Est. weight
1,112
Triangles
Print lying flat in PETG.
Thumb page holder
MAIN PURPOSE: Hold a book open one-handed
Slip your thumb through the ring and the two wings hold a paperback open on both sides, so you can read one-handed on the sofa, the train or the beach.
Printing notes
8.4 cm³
Volume
10.4 g
Est. weight
500
Triangles
Prints flat as a plate, no supports.
Mouse garage
MAIN PURPOSE: Park the mouse out of the way
Park the mouse under a little roof at the end of the day so it stays dust-free and out of the way; the cable runs out through a hole in the back. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
33.4 cm³
Volume
41.4 g
Est. weight
3,060
Triangles
Print floor-down as shown, then turn it over to use it.