Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Paper clip and pin tin
MAIN PURPOSE: Store paper clips and pins
A small round tin with a screw-on lid.
Printing notes
37.3 cm³
Volume
46.2 g
Est. weight
2,420
Triangles
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Labelled drawer cabinet
MAIN PURPOSE: Store stationery and chargers in drawers
A three-drawer desk cabinet with bar handles for stationery, chargers and spare cables.
Printing notes
325.6 cm³
Volume
403.7 g
Est. weight
180
Triangles
Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Spinning art supply caddy
MAIN PURPOSE: Spin art supplies within easy reach
An eight-section art caddy with a centre hub that spins on BBs, with ART on the side.
Printing notes
701.1 cm³
Volume
869.4 g
Est. weight
6,932
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Gridfinity 3x2 desk organizer with baseplate
MAIN PURPOSE: Start a Gridfinity desk drawer system
A six-cell 3x2 Gridfinity organizer and its matching baseplate, a complete desk drawer starter.
Printing notes
84.4 cm³
Volume
104.6 g
Est. weight
4,732
Triangles
Prints as shown on its floor, no supports. The Gridfinity baseplate prints separately.