Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG; add a strip of bike inner tube as the pad. Prints as shown on its outline, no supports.
Tie a 60 cm cord through the centre hole. Prints flat as a plate, no supports.
PETG with solid walls so it holds water; check the inside is 100 mm. Prints as shown on its floor, no supports.
Glue in 2 mm and 3 mm glass beads. Prints flat as a plate, no supports.
PETG, 3 walls; push a short drinking straw into the spout. Prints as shown on its floor, no supports.
White PLA, colour it with markers. Prints as shown on its floor, no supports.
PETG; matt stone-coloured filament looks most natural. Print floor-down as shown, then turn it over to use it.
Print six or more. Prints as shown on its floor, no supports.
Print one per track in each player colour; PETG springs best. Prints as shown on its outline, no supports.
Print a set per player in their colour. Print floor-down as shown, then turn it over to use it.