Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Nurse pocket organiser
MAIN PURPOSE: Organise a uniform pocket
Drops into a scrubs or tunic pocket and keeps pens, a penlight, scissors and tape upright in their own slots, so nothing falls out when you bend down.
Printing notes
14.0 cm³
Volume
17.3 g
Est. weight
1,028
Triangles
Prints as shown on its floor, no supports.
Floral ribbon dispenser
MAIN PURPOSE: Dispense ribbon from reels
Dispenses up to three ribbon reels for a florist or gift-wrapping table: slide a rod through the side holes and the reels, and pull each ribbon out through its front slot.
Printing notes
46.0 cm³
Volume
57.0 g
Est. weight
3,284
Triangles
Prints as shown on its floor, no supports.
Classroom hall pass
MAIN PURPOSE: Let pupils leave the classroom with a pass
A tough hall pass for school corridors: hang it on a lanyard through the hole, and the class name goes in the raised text.
Printing notes
31.1 cm³
Volume
38.6 g
Est. weight
8,792
Triangles
Prints flat as a plate, no supports.
Egg candling cup
MAIN PURPOSE: Candle eggs during incubation
Check hatching eggs for growth: slip the cup over a small torch or a phone light, rest the egg on the soft rim and look for veins and movement in a dark room.
Printing notes
16.5 cm³
Volume
20.4 g
Est. weight
848
Triangles
Prints as shown on its floor, no supports.
Jeweller's bench pin
MAIN PURPOSE: Support work for jewellery sawing and filing
Clamp it to the bench edge to support silver sheet and wire while you saw, file and drill; the V cut-out lets the saw blade pass right through.
Printing notes
44.4 cm³
Volume
55.0 g
Est. weight
476
Triangles
Prints as shown on its outline, no supports.
Caulk nozzle caps
MAIN PURPOSE: Keep opened sealant tubes from drying out
Push one onto a cut caulk or sealant nozzle and the tube stays usable for weeks instead of curing solid.
Printing notes
1.6 cm³
Volume
2.0 g
Est. weight
680
Triangles
Print a handful; TPU seals best. Prints as shown on its floor, no supports.
Doorway threshold ramp
MAIN PURPOSE: Smooth a step at a door threshold
A low ramp for a door threshold up to 22 mm high, so robot vacuums, wheeled bins and walkers roll over instead of getting stuck.
Printing notes
185.2 cm³
Volume
229.6 g
Est. weight
260
Triangles
Print as it comes (ramp outline on the bed); print two side by side for a wide door.
Stick vacuum accessory pegs
MAIN PURPOSE: Store vacuum attachments on the wall
Screw the plate to the wall beside a stick vacuum and park its crevice tool, brush and extension on the three pegs. Print it lying flat; on the wall the pegs point straight out.
Printing notes
144.9 cm³
Volume
179.6 g
Est. weight
3,028
Triangles
Prints flat as a plate, no supports.
Chair caster cup
MAIN PURPOSE: Protect floors under casters
Stops chair and sofa casters rolling and scratching wooden floors: the wheel sits in the inner ring and the grip feet hold the cup still.
Printing notes
20.5 cm³
Volume
25.4 g
Est. weight
1,168
Triangles
Print four in TPU or PETG. Prints as shown on its floor, no supports.