Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The long side slot takes a pencil and a mini spirit level. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Only put tips away cold. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PLA or PETG; print the lid face down for a flat top. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Fill the race with 6 mm airsoft BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.