Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food contact: line the bays or use food-safe PETG and wash by hand. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Food-safe PETG; the lid keeps leftovers in the fridge in the same tray. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Food-safe PETG; keep it away from the window. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Load a stack of flat shoe covers through the top; screw to the wall at shoe height. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Drop in three nursery pots up to 9 cm; give it a third of a turn every morning. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.