Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print drawers in a darker colour for the kaidan look. Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Twelve 6 x 3 mm magnets, same polarity rule. Prints as shown on its floor, no supports. The drawer prints separately from the case.
PETG; clean with alcohol before pouring agar. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in stone grey; core in a silk colour if you swap filament. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print body and lid flat. Optional 10 mm magnet glued under the floor. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Print in white or pearl PETG. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Print body and lid flat. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
PETG, 3 walls; PTFE tape on the thread. Test it with your keys first. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print upright; stand it in a tray of damp perlite. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.