Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Wind about 60 turns of 0.3 mm enamelled wire on the tube; use a 1N34A germanium diode, a crystal earpiece, 20 m of aerial wire and a ground to a metal water pipe. Prints as shown on its floor, no supports.
Holes fit 12 mm toggles, 7 mm rotary encoders and a 22 mm start button; the back port takes a USB-C cable. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
PETG or ASA near the iron. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
A drop of glue holds the bit for good. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints flat as a plate, no supports.
Prints as shown on its outline, no supports.
Print two in PETG or ASA. Prints flat as a plate, no supports.