Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the turntable ring separately and drop in 6 mm steel or airsoft balls. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the sleeve upright and the two drawers flat; line the cells with felt for wooden pieces. Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Sized for travel checkers up to 34 mm across; scale the tubes for full-size checkers. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added bases' lids print separately.
Print two, one for each player; a wood-fill filament suits the game. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.
Light colour so the ball shows. Use an 8 mm steel ball. Prints as shown on its outline, no supports.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print two flat in PETG, 4 mm, in two colours. Prints flat as a plate, no supports.
Print in black; fill with cork or putty. 6 x 2 mm magnet. Prints as shown on its outline, no supports.
Print open side up, glue in a coin, then flip. Print floor-down as shown, then turn it over to use it.