Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Feed boards safely past a cutter
Keeps your hands well above the cutter when you feed a board over a jointer or across a router table: hold the tall handle and press the grippy base down onto the wood.
Printing notes
70.8 cm³
Volume
87.7 g
Est. weight
2,008
Triangles
Print the base in TPU, or stick rubber grip tape underneath. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Router circle cutting jig
MAIN PURPOSE: Cut circles with a router
Cuts perfect circles with a palm router: screw the router base to the wide end, put a nail through one of the pivot holes into the centre of the board, and swing the router round.
Printing notes
67.9 cm³
Volume
84.2 g
Est. weight
1,988
Triangles
Prints flat as a plate, no supports.
Joinery biscuit box
MAIN PURPOSE: Sort joining biscuits by size
Three bays for #0, #10 and #20 joining biscuits, with the sizes raised on the telescoping lid.
Printing notes
266.5 cm³
Volume
330.4 g
Est. weight
9,744
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Bench cookie riser
MAIN PURPOSE: Lift work off the bench
A ribbed riser that lifts work off the bench for routing, sanding and painting, with a honeycomb grip on top; print a set of four. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
31.7 cm³
Volume
39.3 g
Est. weight
5,704
Triangles
Print floor-down as shown, then turn it over to use it.
Corner clamping square
MAIN PURPOSE: Clamp box corners at ninety degrees
A rigid 90-degree square for gluing up boxes and frames, with a relief notch in the corner for glue squeeze-out and slots for the clamp jaws.
Printing notes
46.8 cm³
Volume
58.1 g
Est. weight
1,564
Triangles
Prints as shown on its outline, no supports.
