Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print one per player. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Print in a dark colour. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Add 60 cm of cord and two 15 mm beads. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 2 mm wire, a buzzer, a 5 mm LED and 2 AA cells. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Prints flat as a plate, no supports.
Print twenty or more. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 50 cm of cord and a table-tennis ball. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG for water play. Prints flat as a plate, no supports.