Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Windscreen ice scraper
MAIN PURPOSE: Scrape ice off car windscreens
A flat ice scraper with a wide blade for windscreens and a long, narrow handle that keeps your knuckles off the glass; print it in PETG so it stays tough in the cold.
Printing notes
42.4 cm³
Volume
52.6 g
Est. weight
1,444
Triangles
Prints flat as a plate, no supports.
Bike tyre lever
MAIN PURPOSE: Remove bike tyres from rims
A stiff tyre lever with a spoon tip that slides under the bead and a hooked tail that clips onto a spoke; print two or three in PETG or nylon for the saddle bag.
Printing notes
12.5 cm³
Volume
15.4 g
Est. weight
252
Triangles
Prints flat as a plate, no supports.
Olive and pit moat dish
MAIN PURPOSE: Serve olives and catch the stones
An oval olive dish with a second wall inside it: olives sit in the middle and the stones drop into the channel that runs all the way round.
Printing notes
120.3 cm³
Volume
149.2 g
Est. weight
1,008
Triangles
Prints as shown on its floor, no supports.
Sushi board with soy and wasabi wells
MAIN PURPOSE: Serve sushi with soy and wasabi
A low serving board on raised feet, with two small wells at one end for soy sauce and wasabi and softly rounded rims.
Printing notes
104.3 cm³
Volume
129.3 g
Est. weight
2,976
Triangles
Prints as shown on its floor, no supports.
Butter keeper with telescoping cover
MAIN PURPOSE: Keep a block of butter covered
A butter dish for a full block, with a telescoping cover and knob, rounded rims and feet that lift it off the counter.
Printing notes
123.8 cm³
Volume
153.6 g
Est. weight
6,940
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Cheese board with knife inlay
MAIN PURPOSE: Serve cheese with its own knife
A solid-looking serving board with a cheese knife shaped recess along the front edge, so the knife always has its place.
Printing notes
501.1 cm³
Volume
621.3 g
Est. weight
5,352
Triangles
Prints as shown on its floor, no supports.
Herb keeper with stem holes
MAIN PURPOSE: Keep fresh herbs upright in water
A water reservoir for fresh herbs with a fitted top plate: six holes hold the stems upright, and HERBS is engraved on the front.
Printing notes
93.5 cm³
Volume
115.9 g
Est. weight
6,948
Triangles
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Avocado half saver
MAIN PURPOSE: Keep a cut avocado half fresh
An avocado-shaped keeper with a telescoping lid that keeps a cut half fresh in the fridge.
Printing notes
64.7 cm³
Volume
80.2 g
Est. weight
1,144
Triangles
Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Pizza slice saver
MAIN PURPOSE: Store a leftover pizza slice
A triangular container that fits a leftover slice, with a lift-off lid, bar handle and PIZZA on top.
Printing notes
225.2 cm³
Volume
279.2 g
Est. weight
756
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
