Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Blow gently across the hole, not into it. Print with 3 walls so the jar rings clearly. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Press or glue a 10 mm disc magnet into each seat from below. Prints as shown on its outline, no supports.
Lanes fit medium and large hens' eggs. Prints as shown on its floor, no supports.
Print in PETG for the bath. Let it dry upside down. Prints as shown on its outline, no supports.
Rinse twice a day. Empty the bottom tray each time. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Smooth walls help: print the walls with no texture. Prints as shown on its floor, no supports.
Print two and play from opposite ends of the table. Prints as shown on its floor, no supports.
Print in grey or stone-effect filament. Place it lid-down. Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Cut the glass or acrylic about 195 x 115 mm. Stand it on a saucer. Prints as shown on its floor, no supports.
Print in PETG. For very fine tea, line it with a paper filter. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.