Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print three or four; 8 mm dowel. Prints as shown on its floor, no supports.
Print upright; push the dowel into the post. Prints as shown on its floor, no supports.
PETG or ASA for heat; print flat.
Print upright; tabs come out hollow. Prints as shown on its outline, no supports.
Print the lid separately, upside down. Prints as shown on its outline, no supports. The lid prints as a separate part, top down.
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Twelve 6 x 3 mm magnets, same polarity rule. Prints as shown on its floor, no supports. The drawer prints separately from the case.
Twelve 6 x 3 mm magnets. Prints as shown on its floor, no supports.
Print flat in PETG, 2 mm; print six to ten.
Print as it comes (comb on the bed), solid; fix with foam tape.